March 29, 2024, 02:21:25 PM

Author Topic: not seeing my Promise IDE Ultra 133 controller  (Read 7215 times)

tak00

  • Member
  • *
  • Posts: 3
not seeing my Promise IDE Ultra 133 controller
« on: April 28, 2004, 03:04:15 PM »
I don't see my Promise Ultra 133 IDE controller on the IDE Devices tab. I do see the disk drive that is attached to it on the Drives tab. Is this supported or possibly a bug?

Komodo Support

  • Administrator
  • Member
  • *****
  • Posts: 2702
  • Dayton, Ohio, USA
not seeing my Promise IDE Ultra 133 controller
« Reply #1 on: April 28, 2004, 06:23:16 PM »
The IDE/SCSI Devices tab only shows drive information and not all IDE devices as you may think.  We are looking into the possibility of collecting all data about installed devices similar to the information provided by the Device Manager in Windows itself.

Indirectly, this is a very good point you've brought up.  There are two tab names are a little ambigous.  Our "IDE/SCSI Devices" tab should actually be renamed to "IDE/SCSI Drives" and the "Drives" tab renamed to "Logical Drives" or "Drive Letters".

We will make this change in the next release.  Thank you for bringing it to our attention.